| |
| Men’s Suit Stitching:- |
| |
- Stitching is the base for holding up all the parts of Men’s suits. It is also the feature of quality in the work of a tailor or designer.
- High quality suit need neat and firm stitching on all parts on Men’s suits.
- Hand stitching is the top but its finish is usually uneven compared to machine-stitch.
- The buttons and button holes are appropriately positioned to check the quality of stitch.
|
| |
| Lining or Coating for Mens Suit:- |
| |
- The purpose of lining is to give reassure for the wearer. It also covers unsightly mens suits details like seams and fuses that hold the suit together.
- The lining support to keep away from contact of these seams and fuses from the body as well as cover up these unsightly sewing. Men's suits can be “fully lined” can be defined with line 3/8 of the suit jacket or “partially lined” can be defined with ½ suit lining.
- Your choice for suit linings should be rayon, Cupro Bamberg, or silk since they provide a smooth and silky feel.
- One of the key mens suits particulars about lining is to avoid it slumped below the suit. A well finished lining should be firm and short of the edge of the suit.
|
| |
| Waist for Men’s Suit:- |
| |
- Tie up the waist button and then place both arms by your sides. In case any buckling at the button holes or buttons seemingly popping out, then your mens suits fitting is too tight around your waist.
- There are some jackets narrowed at the waist, and still we should not see such negative effect after fastening the waist button. Always remember that the silhouette and drape of the suit should be smooth and flat.
|
| |
| Pocket Style for Men Suit:- |
| |
- Pockets are vital in men’s suits because its fashions can vary on special suits.
- A popular tailoring for pockets is the besom. It is an inset pocket sewn inside the garment with access through a fine welted slit-type opening.
- Three types of pockets are popular on suits are slit pockets, flap pockets and high-class pockets. Slit pockets represents a slit style which gives a clean finish on the suit’s hip area. Usually the slit pockets are jetted at the opening of the pockets. Flap pockets are extra fabric on covering the outside of the pocket opening. A high quality pocket allows both a slit pocket and flap pocket. It is required to be double-besomed so that it becomes a slit pocket when the flap is inserted into the pocket. It gives exchange looks on a single suit.
|
| |
| Vent in Men’s Suit:- |
| |
- In Mens suit, vents are upright slit openings creating flaps at the lower back of suits.
- Vents are tailored to offer liberty and room for movement around the hip area of the suit. Without a vent, it can cause the suit to crumble and experience tight at the hip area.
- Vents should have the one of the flaps overlap the other by about ¾ inch and not reveal the pants through it.
- The three popular kinds of vents in suits are single vent, double vent and vent-less.
- In single vents, the slit opening is at the center lower back of the suit. This is a typical look found among American-style suit.
- In double vents, vents are cut symmetrically on both sides of the hip area of the men suit. It provides more freedom of movement than single vents. It also emphasizes the lines of the body.
- In Vent-less there is no vent. Vent-less suit can limit movement like raising your arm or sitting. It is more appropriate for slimmer man.
|
| |
|
|
